Solved FEA Pack 16 (Cases 151-160)
Get these FEA files to see the settings we used for materials, mesh, contacts, loads, time steps, solver etc. On this page you find only MECHDAT or WBPZ files and 3D models, while the PDF tutorials are found on the TUTORIALS and SHORT TUTORIALS pages!
ANSYS WB 15 OR HIGHER
Click for video with results on Get the ANSYS WB 15 MECHDAT file + the 3D model for only $15 
ANSYS WB 17.1 OR HIGHER
Click for video with results on If you have at least ANSYS WB 17.1, Get the ANSYS Workbench data as MECHDAT file + the 3D model for only $17
ANSYS WB 15 OR HIGHER
Click for video with results on Get the ANSYS WB 15 MECHDAT file + the 3D model for only $15
ANSYS WB 15 OR HIGHER
Click for video with results on Get the ANSYS WB 15 MECHDAT file + the 3D model for only $16
ANSYS WB 15 OR HIGHER
Click for video with results on Get the ANSYS WB 15 MECHDAT file + the 3D model for only $15
ANSYS WB 15 OR HIGHER
Click for video with results on Get the ANSYS WB 15 MECHDAT file + the 3D model for only $17
ANSYS WB 15 OR HIGHER
Click for video with results on Get the ANSYS WB 15 MECHDAT file + the 3D model for only $16
ANSYS WB 19 OR HIGHER
Click for video with results on Only if you have ANSYS v19 or higher, Get the ANSYS Workbench data as MECHDAT file + the 3D model for only $17
ANSYS WB 19 OR HIGHER
Click for video with results on Only if you have ANSYS v19 or higher, Get the ANSYS Workbench data as MECHDAT file + the 3D model for only $17
ANSYS WB 19.1 OR HIGHER
Click for video with results on Only if you have ANSYS v19.1 or higher, Get the ANSYS Workbench data as MECHDAT file + the 3D model for only $17
☆ The MECHDAT files give you hints for your FEA work or training, by observing our set-up: geometry, materials, mesh, boundary conditions, analysis settings and solution items as seen in their YouTube clips. Solving is not guaranteed 100%, because ANSYS continuously changes the solving algorithms; usually they do a good job, sometimes...
☆ After you made the purchase, open the MECHDAT file and re-solve the FEA as follows:
⇒ for Static and Transient Structural: right click Solution, Clear Generated Data, Solve;
⇒ for Explicit Dynamics: right click Solution, Clear Generated Data, then go to Analysis Settings, Step Controls, Resume From Cycle = 0, Solve.
☆ BE SURE TO HAVE THE SAME OR EVEN A NEWER ANSYS VERSION, BECAUSE OLDER VERSIONS WILL NOT OPEN THE NEWER FILES!